> 7AMP :
3-band Distortion
Win32    VST
VST rate
3.1 / 5
(7 votes)

3-band Distortion - 3 band distortion
3 band distortion.
  • State turns on and off particular distortion band.
  • Tone tunes the frequency of the input filter.
  • Band tunes the bandwidth of the input filter.
  • Color defines the clipper cutoff level i.e. distortion amount.
  • Knee defines the clipper knee size that makes the effect softer.
  • Feedback changes one internal clipper property relative to saturation, feedback and asymmetry.
  • Asymmetry makes the effect asymmetric including time asymmetry during signal period.
  • Level sets output level of particular band.
  • Tone tweak frequency of the output filter.
  • Band bandwidth of the output filter.
  • Speaker turns on speaker simulation.

(0.15 Mb)
  V 1.05


Submit new comment

Feb 08 2016
  5  / 5
It was the least liked distortion VST I had on my drive until a few minutes ago I found out how to actually use it properly and I think it got me turned on.
Reply < > New comment

Submit a comment  * (*) Comments are validated before published   
VST plug-in
    3-band Distortion
Rate it  
or not...
Audio code
Please type this code :