> Signaldust :
Sweep
Win32 Win64    VST
 
VST rate
3.8 / 5
(4 votes)


Sweep - Morphing filter
This rather unremarkable filter was designed for manual (or automated) filter sweeps.

The cutoff covers the whole audio range (and then some). The resonance goes from none to fairly soft self-oscillation. The filter will morph from lowpass to notch to highpass. An additional bandpass response can be cross-faded with the morph results. The final wet signal can further be cross-faded with the dry input. Additional output level trim is provided for convenience. Using a MIDI controller is highly recommended.

For random knob tweaking, the Q range can be limited to "safe" settings with maximum resonance setting mapping to 75% of the "full" range. With higher drive settings you should expect some (or all) of the resonance replaced with true-stereo distortion.

In practice, it might not be totally useless as sound-design tool and with low to moderate drive settings it can also serve most "utility filter" duties. Experiment.

(0.68 Mb)
(0.7 Mb)


 

Submit new comment

Jan 06 2016
  Does it job but...
VST
  2  / 5
It sound OK, but there's a big problem. (At least I have it). It makes my channels buzzing constantly... And yes, it is this plug-in, because when I turn this off, the "murmur" sound stops.
Reply < > New comment

Feb 07 2015
  Chihuahua
VST
  ?  / 5
My graphics card doesn't support whatever crazy thing this does visually...
Reply < > New comment

 
Submit a comment  * (*) Comments are validated before published   
 
VST plug-in
    Sweep
   Signaldust
   
Rate it  
or not...
             
 
   
Name  
 
 
Audio code
Please type this code :
CODE