> Nick Crow Lab :
TubeDriver
Win32 Win64 OSX    AU VST
 
VST rate
4.5 / 5
(2 votes)


TubeDriver - Tube amplifier
TubeDriver is a tube amplifier emulation.
  • Pre EQ - High Pass, Peak, Shelf and resonant Low Pass filters.
  • BIAS - Adjusts tube stage’s grid bias which control the symmetry of the tube amp saturation.
  • DRIVE -Amount of gain applied by the tube amp.
  • VOLUME - Output level..
  • BOOST - +12 db additional gain applied by the tube amp.
  • BYPASS - Switch TubeDriver in bypass mode.
  • MONO - Switch TubeDriver in mono mode - process Left Input, output Left and Right.
  • PHASE - Invert phase of output signal.
  • HP Freq – Post High Pass Filter frequency.
  • LP Freq– Post Low Pass Filter frequency.
  • Oversample - Oversampling Rate in realtime.
  • 16x On Render – Oversampling Rate in Render (Mixdown) mode of host:
  • OFF - Oversampling Rate in Render (Mixdown) mode of host same as in realtime;
  • ON - Oversampling Rate have a maximum (16x) value in Render (Mixdown) mode of host.


(0.83 Mb)
  V 1.22
(0.84 Mb)
  V 1.22
(2.3 Mb)
  V 1.22
(2.3 Mb)
  V 1.22


 

Submit new comment

Sept 26 2016
  Sphere
VST
  4  / 5
Very good for guitar dynamics.
Reply < > New comment

Aug 11 2015
  charlie
VST
  5  / 5
I use this plugin as a pre-amp when I record vocals and acoustic instruments. I like how it shapes the sound for me. It's one of my three go-to plugin when recording along with Eventide's UltraChanel and Nick Crow's Wagner Sharp.
Reply < > New comment

 
Submit a comment  * (*) Comments are validated before published   
 
VST plug-in
    TubeDriver
   Nick Crow Lab
   
Rate it  
or not...
             
 
   
Name  
 
 
Audio code
Please type this code :
CODE